Painting Beautiful Beach

Published March 24, 2007 | By admin

How To Paint Garage Doors

Hardboard garage doors come with a surface either unprimed or primed. Although the American Hardboard Association offers advice on garage doors that may be old, they also provide information for finishing doors if they've just been bought. There are a number of surface defects that shorten the life of its coating, like knots, raised grains etc, which are not present on the hardboard; making it ideal for coating application.

Wood is used to make the hardboard that is used for garage doors. The life of the door as well as that of its coating is enhanced if its initial coating is done appropriately. The coating is not just meant to enhance the look of the door, but also enhance its durability. These recommendations act like guides so that both the functions to get a reasonable service life on the hardboard garage doors. To explore the area of garage doors browse our site on Garage Roller Door.

To ensure that the garage door stays well protected and lasts long, the following tips must be kept in mind. Unprimed hardboard garage doors must be coated immediately after installation, while the primed ones can be given up to 15 days between installation and finishing. One shouldn't be particular just about buying a coating ideal for finishing the hardboard exterior of the garage door, but should also not compromise on the quality.

It should moreover be of a good quality, which can be assessed by the ingredient list on its label. A finish performance warranty is preferred the most. Re-check the package to remove any doubts about the paint or stain's ability as the coat for the exterior of a hardboard garage door. Then on you will need to seal the back, face, and all the edges of the door; which is done with the use of a primer , an oil primer or alkyd primer. Before picking one that may not be based on oil or alkyd, the container's label must be thoroughly read to figure if it can still be used for priming hardboard surfaces.

Using an exterior top coat based of acrylic latex, oil base or alkyd base will be the most beneficial. Once a stain comes on smooth hardboard, it stays while that on the textured hardboard can be dealt with. The opaque acrylic latex stains demonstrate the best results. Prior to applying it on the board, make it free of all form of dirt. You are reading valuable tips on garage doors and can learn more at garage door.

It is important to understand what the makers of the product have to say about the correct primer requirements, hardboard surface temperature, rate of spread and recommended application procedures. The thickness of the film on the wood surface should be near about four millimetres when dry.

If you applied it at the spread rate prescribed on the finish label, you will easily achieve the required thickness. Therefore, apply the following number of coats to outside, inside and all edges of the door before installation. Two un-thinned finish coats follow the primer applied if the door is unprimed and the finishing can be achieved by painting or staining. Remember to spot prime, using an alkyd oil primer, any area of damage to the factory primer. Drying up of the coats of primer should be followed by applying two finish coats.

A little touch up after cleaning the surface of the door will be sufficient if the finish appears in a good condition. After some time the finish coating will begin to erode and thin down and to deal with this start by cleaning and priming the damaged areas where the substrate is exposed and then move on to complete pruning and finish coating. A finish coating will be all that is required if the substrate is not yet visible through the erosion.
Watercolor Seascape Painting Demonstration of Florida Delray Beach at Dawn by Janet Zeh Original Art